Wheel Wells for RGT Intruder EX86020

What This Is

Wheel wells for the RGT Intruder EX86020. This is a gorgeous vehicle and it deserves the best!

What’s Included

The zip file below contains:

• A printable STL file for each wheel well (4 total)
• Read Me.txt

How to Print

I printed in PLA+, though PLA, PETG and other rigid filaments should be fine. I’d suggest these settings:

– 0.4mm nozzle (or bigger)
– 0.24mm layer size (I used 0.3mm with my 0.6mm nozzle)
– 3 to 6 wall width (or wall or shell layers)
– 20% infill, cubic (10% minimum) – doesn’t really matter, it’s all walls
– Supports on base only, 30% angle. Only need to support the flat parts where the wells ‘wings’ need support.

Installation

• Print per the above settings.

• Hold the wheel wells over the chassis to see where the screws need to come out.

• Do one corner at a time; remove the screws from the matching holes.

• Move the top of the shock to fit (I stood mine up; good for a scale car)

• Align the wheel well where it’s supposed go and use screws that are 4mm longer than the stock ones (I think you need 4x 18mm screws and 4x 14mm screws, plus 4x 12mm screws and locknuts to suit for the top of the rear shock hoops if you want to add them too. Not critical).

• Repeat for the other corners. It’s pretty intuitive; these should be plug and play.